homebrewandbeer.com

Ok now i know sevral of you run your beer thou a filter some were between 1 micron and 0.5 usalying when racking ..
What i wanted to know has anybody tryed, or have knolage of hooking one of these filters below inbeween the keg and the tap.. a was thinking it would be great to have this srewed to the inside of the fride door inline just b4 the tap on the out side of the door .. ?
Any thoughts boyz and girls ?




Gym_

Yep. Check this out

http://hopwild.com/2008/01/29/build-you ... r-randall/

If you try pushing carbonated beer through a .5 micron filter you will end up with a sh**load of foam and SFA beer to drink.
Forget it'.

To get around the problem of foaming, you simply replace the filter cannister with a length of pipe that stops about half an inch short of the bottom of the filter unit. That means the beer has to pass through the hop filled cannister before exiting....ie, you turn it into an Organoleptic Hop Transducer....aka, Randall. Doc over on the aussiehomebrewer forum built a double hopback this way!!



Alternatively, you could build your own ghetto hopback with a jar;


Cheers,
TL