Page 1 of 1
Tool to remove Corny keg valves?
Posted: Thursday Feb 01, 2007 3:46 pm
by rwh
Hi all, I've got a Corny keg that I want to replace the seals on. What tools do I need to get the valves off? The gas IN valve has a weird star shaped nut that needs to be unscrewed, and the beer OUT valve has a standard nut, but the handles obstruct my shifter so I can't use that...
Posted: Thursday Feb 01, 2007 4:03 pm
by Rysa
http://brewingtechniques.com/library/ba ... ngsb1.html.
I found this but as for where to get a tool that specifically does the job?
Posted: Thursday Feb 01, 2007 4:07 pm
by Rysa
Also read about using a long socket but haven't had a great deal to do with kegs myself only through my brother in law.
Posted: Thursday Feb 01, 2007 8:41 pm
by gregb
7/8 inch ring spanner for the star shaped looking one. The other ones are 11/16. Well, on my corny's so far.
Cheers,
Greg
Posted: Friday Feb 02, 2007 8:03 am
by Hashie
I have 9 kegs and they all have the same fittings. As gregb said, a 7/8 combination spanner is the go. The ring end will do the gas post while the beer post can be done with either end of the spanner.
SPAM!!!
Posted: Wednesday May 16, 2007 12:16 am
by Krusty
DO NOT CLICK THE ABOVE LINK!!!!!
I reckon it could well be harmful. Anyone trust their antivirus enough to give it a go?
Posted: Wednesday May 16, 2007 5:10 am
by gregb
I made the link go away.
Cheers,
Greg
Posted: Wednesday May 23, 2007 2:43 am
by Dogger Dan
I just use a set of vice grips.
Dogger
Posted: Monday May 28, 2007 7:34 pm
by Trough Lolly
A deep star socket from AutoPro for $10 and you're up and running...
Cheers,
TL